Less Lethal for Dummies

RSS

Reviews, mods, power testing and most of all...fun

Questions, comments, concerns or secrets?

LLforDummies@gmail.com

View channel on YouTube

Switch Invidious Instance

Videos

Shorts

Playlists

Posts

Less Lethal for Dummies

Almost there!

17 hours ago | [YT] | 78

View 7 replies

Less Lethal for Dummies

Byrna CLXL

Time to fix a few things.
-Sub 400fps right out of the box
-12g adapter that pulls away
-Nasty leak

The sub 400fps numbers may have been directly related to the leak that developed after only 6 CO2s.

I needed that K20 Tools 12g adapter from my CL, that’s why it is getting pillaged.

1 day ago | [YT] | 95

View 13 replies

Less Lethal for Dummies

Beeman BP50

Googly eyes 👀 fix everything, even mag drops. That should hold the detent in place.

6 days ago | [YT] | 247

View 19 replies

Less Lethal for Dummies

Beeman BP50 Aluminum Follower

HomeDefence-24 50cal Destroyer projectile, drilled 5/64” through and through, and then just hammered in 2mmx16mm knurled dowel pin.

Does it work?…good question 😆

Update: LL4D - Beeman BP50 | Aluminum Follower Test
youtube.com/shorts/gclc6XqPDp...

1 week ago (edited) | [YT] | 244

View 25 replies

Less Lethal for Dummies

TITAN Tactical Systems 20rd drum magazine for your Beeman BP50.

You can purchase their products through the official website which now directly links to their eBay store for secure transactions with peace of mind.

Initial thoughts…DANG! Just like the Defender 07 body kit also pictured here the drum is very well finished. A very polished looking piece with a surprise that even I missed. 👀

Stay tuned for assembly and testing.

Check them out here ⬇️
titantacticalsystems.com/

2 weeks ago | [YT] | 286

View 22 replies

Less Lethal for Dummies

Ever seen one of these? Side lever springer…
https://youtu.be/aRkIC3i4o2I?si=cJUC8...

2 weeks ago | [YT] | 42

View 2 replies

Less Lethal for Dummies

Beeman BP50

Doing a little LL4D tune-up.

Set the HomeDefence-24 tuning barrel with an oring seal at the breech instead of the PTFE tape that quickly blew out under higher pressures.

I also shaved the spring sleeve down to approximately 17mm from the factory 18mm length. This allows the bolt to travel further forward during the release. I am hoping this can help lower the amount of blow-by down the magwell that is releasing our magazines. I can take the sleeve down another mm or so before the bolt spring itself acts as the stop. Time for testing.